*Refer to "running the speaker wires" instructions
located below these installation instructions before installing
your S-Pods.
Tools required for installation:
1 Phillips Screwdriver
Step 1: Move seat forward
and remove the two screws
holding the interior panel as
shown. Remove interior panel.
Step 3 : Insert one short screw into
one of the upper mounting holes of
the speaker mounting plate. Start the
screw into the corresponding nutsert
in the rear backing plate.
Step 2: Set the rear cover
inside the roll bar hoop.
Step 5.  Insert speaker wires into wire
concealer and attach wire concealer     
as shown below.  (note: Area where      
the concealer attaches must be          
cleaned prior to attachment).   
Step 7.  The speaker grille attaches by pressing
clips into the speaker mounting plate. (No illustration)
Step 6.  Connect wire to speakers and install
speakers. (No illustration)
(note: double-stick tape is provided for
mounting tweeters.)
Step 4.  Insert and tighten the remaining
screws by hand. Important: Do not
use an electric screwdriver. It will
over-tighten the screws possibly
damaging the S-Pod. The screws
need to be "snug", and will gently
pull the rear cover into perfect
alignment as you tighten them.
(No illustration)
:: Mounting Instructions ::
:: S-Pod installation instructions ::
:: Running the speaker wires installation instructions ::
Note: Stereo deck removal and installation instructions are not included with S-Pods® .   
They are available at www.s2ki.com, or you may have a local professional             
installer complete the hook-up.
Step 1:  Remove the driver’s side
knee pad and pull about 12in. of  
wire through the opening to allow
easy connection.        
Step 2.  Remove the console cover retaining clips on    
the left side and feed the wires under the cover.
Step 5.  Pull the right wire behind the center
console from the left to right cavity. Connect to
the right speaker.
Step 4.  Now run the wires into the open cavity and
connect one to the left speaker.
Step 3.  Replace the clips while tucking
          the wires under the cover.
Final Step.  Replace the interior panels and the
rear speaker installation is complete. (No
illustration)
Note:  Speaker wire is not included with S-Pods®. It is not necessary to    
use flat wire as shown in these instructions.
COMPLETED INSTALLATION -